JA
  • English
Login

Colour bleeding

Menu

Colour bleeding

Colour bleeding
Relevant for:
MMU1
Last updated 3 years ago
Colour bleeding
 Difficulty
Moderate
 Steps
3
 Available languages
EN

Step 1 Issue description

Issue description
Issue description
This guide is obsolete. For more info on this topic, please see パージボリューム.
⬢Issue is well known that it leaves traces of previously used colour in each layer as you can see in the picture.
For some filaments or color combinations ( such as black color together with white color ) additional wipe area might be needed. The default value works with most materials and color combinations.

Step 2 Fix (newer version)

Fix (newer version)
Fix (newer version)
Fix (newer version)
For this step you need Slic3r PE 1.35.1 or newer. Software is part of drivers package prusa3d.com/drivers/
⬢Open Slic3r PE with your model and switch to tab "Print Settings".
⬢Increase the value "Per color change depth" by few millimeters.
⬢Process the G-code again and save it on your SD Card.
Please keep in mind that increasing wipe width causes longer print times and higher material consumption.

Step 3 Fix (older version)

Fix (older version)
Fix (older version)
Fix (older version)
This step is no longer needed if you have installed Slic3r PE 1.35.1 or newer.
⬢Turn on "Advanced mode" by checking highlighted box.
⬢Increase "Width of wipe" by few millimeters.
⬢Process the G-code again.
Please keep in mind that increasing wipe width causes longer print times and higher material consumption.
Was this guide helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us