1. 組み立てを始める

プリンターメンテナンス

• How to install the Nextruder V6 nozzle adapter (CORE One L)
• How to replace the Prusa Nozzle (CORE One L)
• How to replace a hotend assembly (CORE One L)
• How to replace the hotend fan (CORE One L)
• How to replace the side filament sensor (CORE One L)
• How to install the advanced filtration (CORE One L)
• How to replace a Hotend Heater (CORE One L)
• How to replace a Hotend Thermistor (CORE One L)
• How to replace Nextruder Filament Sensor (CORE One L)
• How to replace the print fan (CORE One L)
• How to replace the Accelerometer (CORE One L) [進行中の翻訳]
  1. 組み立てを始める
  2. Introduction
  3. Tools Required
  4. Printer Preparation
  5. Printer Preparation 2
  6. Top Cover Removal
  7. Heatbed Protection
  8. PTFE Disconnection
  9. Left Cover Removal
  10. Print Head Preparation
  11. Print Head Preparation 2
  12. Accelerometer Removal
  13. Accelerometer Preparation
  14. Accelerometer Installation
  15. Cable Guidance
  16. Rear Cover Installation
  17. Print Head Covering
  18. Top Cover Attachment
  19. Power Up
  20. Final check
• How to replace Hotend Heatsink (CORE One L)
• How to reverse the door orientation (CORE One L)
• How to replace Loveboard (CORE One L)
• How to replace a Hotend Thermistor (CORE One L)