1. 組み立てを始める

プリンターメンテナンス

• How to install the Nextruder V6 nozzle adapter (CORE One L)
• How to replace the Prusa Nozzle (CORE One L)
• How to replace a hotend assembly (CORE One L)
• How to replace the hotend fan (CORE One L)
• How to replace the side filament sensor (CORE One L)
• How to install the advanced filtration (CORE One L)
• How to replace a Hotend Heater (CORE One L)
• How to replace a Hotend Thermistor (CORE One L)
• How to replace Nextruder Filament Sensor (CORE One L) [進行中の翻訳]
  1. 組み立てを始める
  2. Introduction
  3. Tools Required
  4. Printer Preparation
  5. Printer Preparation 2
  6. Top Cover Removal
  7. Heatbed Protection
  8. Nextruder Cover Removal
  9. Hotend Disconnecting
  10. Hotend Assembly Removal
  11. PTFE Disconnection
  12. Cover Right Removal
  13. Extruder Disconnecting
  14. Extruder Removal
  15. Nextruder Disassembly
  16. Extruder Disassembly 2
  17. Extruder Disassembly 3
  18. Extruder Disassembly 4
  19. Extruder Disassembly 5
  20. Extruder Disassembly 6
  21. New Filament Sensor Preparation
  22. Hall Sensor Installation
  23. Filament Sensor Assembly
  24. Filament Sensor Installation
  25. Heatsink Assembly
  26. Gearbox Assembly
  27. PG-Ring Assembly
  28. Gearbox Assembly
  29. PG-Assembly Check
  30. Nextruder Idler Installation
  31. Gear Lubrication
  32. PG-Cover Installation
  33. Idler Swivel Installation
  34. Heatsink Thermistor Installation
  35. Extruder Installation
  36. Fan Installation
  37. Extruder Connection
  38. Extruder Connection 2
  39. Cover Right Installation
  40. LoveBoard Connection Check
  41. PTFE Installation
  42. Hotend Assembly Installation
  43. Nozzle Check
  44. Hotend Connection
  45. Hotend Cables Guidance
  46. Cover Left Attachment
  47. Top Cover Attachment
  48. Power Up
  49. Final check
• How to replace the print fan (CORE One L)
• How to replace the Accelerometer (CORE One L)
• How to replace Hotend Heatsink (CORE One L)
• How to reverse the door orientation (CORE One L)
• How to replace Loveboard (CORE One L)
• How to replace a Hotend Thermistor (CORE One L)