1. 組み立てを始める

プリンターメンテナンス

• How to rebuild the Nextruder Hotend
• How to install HT Hotend Upgrade (CORE One/+, CORE One L/+)
• How to replace the main cable (CORE One L/+)
• How to install the Nextruder V6 nozzle adapter (CORE One L/+)
• How to replace the Prusa Nozzle (CORE One L)
• How to replace a hotend assembly (CORE One L)
• How to replace the hotend fan (CORE One L)
• How to replace the side filament sensor (CORE One L)
• How to replace the door sensor (CORE One L)
• How to install the Advanced Filtration (CORE One L) [進行中の翻訳]
  1. 組み立てを始める
  2. Introduction
  3. Tools necessary for this guide
  4. Preparing the printer
  5. Advanced filtration: parts preparation
  6. Installing the blower
  7. Installing the sealing foam
  8. Inserting the HEPA filter
  9. Mounting the filtration assembly
  10. Removing the Wi-Fi module
  11. Removing the electronics covers
  12. Connecting the blower cable
  13. Covering the electronics
  14. Attaching the Wi-Fi module
  15. Turning the printer on
  16. Firmware INFO
  17. Well done!
• How to replace the Buddy3D camera cable (CORE One L)
• How to replace a Hotend Heater (CORE One L)
• How to replace a Heatsink Thermistor (CORE One L)
• How to replace Nextruder Filament Sensor (CORE One L)
• How to replace the print fan (CORE One L)
• How to replace the Accelerometer (CORE One L)
• How to replace Hotend Heatsink (CORE One L)
• How to reverse the door orientation (CORE One L)
• How to replace LoveBoard (CORE One L)
• How to replace a Hotend Thermistor (CORE One L)
• How to replace the White LED strip (CORE One L)
• How to pack CORE One L for return
• How to replace the heatbed fans (CORE One L)
• ヒートベッドの交換方法（CORE One L）
• ACボックスの交換方法（CORE One L）