1. 組み立てを始める

プリンターメンテナンス

• How to install the Nextruder V6 nozzle adapter (CORE One L)
• How to replace the Prusa Nozzle (CORE One L)
• How to replace a hotend assembly (CORE One L)
• How to replace the hotend fan (CORE One L)
• How to replace the side filament sensor (CORE One L)
• How to install the advanced filtration (CORE One L) [進行中の翻訳]
  1. 組み立てを始める
  2. Introduction
  3. Tools necessary for this guide
  4. Advanced filtration: parts preparation
  5. Installing the blower
  6. Installing the sealing foam
  7. Inserting the HEPA filter
  8. Mounting the filtration assembly
  9. Removing the Wi-Fi module
  10. Removing the electronics covers
  11. Connecting the blower cable
  12. Covering the electronics
  13. Attaching the Wi-Fi module
  14. Firmware INFO
  15. Well done!
• How to replace a Hotend Heater (CORE One L)
• How to replace a Hotend Thermistor (CORE One L)
• How to replace Nextruder Filament Sensor (CORE One L)
• How to replace the print fan (CORE One L)
• How to replace the Accelerometer (CORE One L)
• How to replace Hotend Heatsink (CORE One L)
• How to reverse the door orientation (CORE One L)
• How to replace Loveboard (CORE One L)
• How to replace a Hotend Thermistor (CORE One L)