1. 組み立てを始める

プリンターメンテナンス

• How to replace the CoreXY plastic parts
• How to replace the print fan (XL multi-tool) [進行中の翻訳]
  1. 組み立てを始める
  2. Introduction
  3. Tools necessary for this guide
  4. Unloading filament
  5. Protecting the heatbed
  6. Preparing the printer
  7. Undocking the nextruder
  8. Disconnecting the nextruder
  9. Accessing the dwarf board
  10. Unplugging the print fan
  11. Accessing the print fan
  12. プリントファンを取り外す
  13. Removing the print fan cover
  14. New print fan - preparation
  15. Inserting the print fan into the fan-cover
  16. 新しいプリントファンの接続
  17. Reattaching the the new print fan
  18. Securing the new print fan
  19. Covering the dwarf board
  20. Securing the toolchanger and the hotend
  21. Connecting the nextruder
  22. Docking the tool
  23. Testing the printer
  24. Well done!
• How to replace the PDU splitter (XL)
• How to replace the main cable connector cover (XL)
• How to install the Nextruder V6 Nozzle Adapter (XL single-tool)
• How to replace the Prusa Nozzle (XL single-tool)
• How to replace the Hotend assembly (XL single-tool)
• Packing printer for transport - Original Packing Material (XL)
• How to change the belt (XL)
• Prusaノズル（XLマルチツール）の交換方法
• How to replace a Z-axis motor (XL)
• Packing the XL Multi-tool for return - Original Packing material
• How to replace a heatbed tile and a heatbed tile cable (XL)
• How to replace a print fan (XL single tool)
• How to fix Modular bed error (HW solution)
• How to replace trapezoid nuts (XL)
• How to clean the side filament sensor (XL)
• How to change xLCD and xLCD cable (XL single-tool)
• How to replace a Dwarf board (XL multi-tool)
• How to replace Nextruder heatsink (XL Multi-tool)
• How to replace a Dwarf board (XL single-tool)
• How to replace the Hotend assembly (XL multi-tool)
• How to replace a hotend thermistor (XL Single-Tool)
• How to replace a Z-axis linear rail (XL)
• How to replace a profile insert (XL)
• How to replace the hotend fan (XL Multi-tool)
• How to replace a PSU (XL)
• How to replace a hotend heater (XL Single-Tool)
• How to lubricate the coupler pins on Original Prusa XL (Multi-Tool)
• How to replace the tch-profile-insert (XL)
• How to replace the Sandwich Board (XL)
• How to replace the rubber band on Original Prusa XL (Multi-tool)
• How replace the CoreXY Cover Rear (Original Prusa XL)
• ネクストルーダーV6ノズルアダプターの取り付け方法 (XLマルチツール)
• How to replace a XY motor (XL)
• Packing the XL Enclosure for return - Original Packing material
• How to change the xLCD (XL)
• How to lubricate linear bearing rails (XL)
• How to set up a Buddy3D Cam
• How to replace Nextruder heatsink (XL Single-tool)
• How to replace a Nextruder (XL single-tool)