IMPORTANT: Continue using the enclosed cardboard to have the back plated lifted from the desk. The reason is that the power button on the PSU, which will be facing down might get damaged.
⬢PSU is mounted using three holes, check the first picture to see where is their location.
⬢Mount the PSU using three M3x18 screws. Tighten them all the way down.
⬢Take the M3x5 screws and screw them in the back plate, 2-3x turns are enough. We will slide a sheet in later on, so don't tighten them. Make sure each screw is perpendicular to the back plate in both axes.
⬢Rotate the tilt preassembly with the hole being on the right side.
⬢Before you attach the cable, make sure you are using the correct hole:
⬢The correct hole for the resin sensor cable.
⬢Incorrect holes, avoid using them.
⬢Place the M4 washer on the correct hole first. Don't place the cable on the tilt, otherwise, you will have issues later!
⬢Add the cable on the top of the washer and secure it using an M4x6r screw. Make sure the cable is facing to the back. Tighten the screw properly, we need the washer to "bite" in the surface of the tilt, but be careful not to damage the screw.
It is very important that the washer is in direct contact with the surface of the tilt. Make sure you didn't switch the order!
If you have a question about something that isn't covered here, check out our additional resources. And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.