⬢マルチプレクサからFestoフィッティングを取り外します。
Use the 8mm side of the wrench, which is part of the upgrade kit.
JA
Login- English
- Čeština
- Español
- Italiano
- Deutsch
- Polski
- Français
- Home
- MMU1
- Troubleshooting [進行中の翻訳]
- プリンタートラブルシューティング
- フィラメントをアンロードできない(MMU1)
フィラメントをアンロードできない(MMU1)
Menu
フィラメントをアンロードできない(MMU1)
Relevant for:
Last updated 9 months ago Difficulty
Moderate Steps
4 Available languages
⬢In case filament is stuck in cooling tube pull cooling tube from filament using gentle force.
⬢If filaments can not be removed using gentle force use lighter to slightly warm cooling tube and using pliers pull cooling tube from filament.
⬢フィラメントを使用して、フィラメントがPTFEチューブに抵抗なく通過できることを確認します。
You should be able to freely insert at least 60 mm of filament.
⬢4つの項目をすべてチェックすること。
⬢Remove screw holding multiplexer in place.
⬢Slide multiplexer up to pull out filament from nozzle.
Pre-heat nozzle in case filament is stuck in nozzle.
⬢フィラメントの端を切ります。
⬢Assemble multiplexer and unload filament.
Was this guide helpful?
Comments
Still have questions?
If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.