Calibration failed

This article is also available in following languages: 

The Calibration failed error occurs once there is a problem with the calibration. The printer was unable to properly detect the calibration point/s and can not successfully finish the calibration. In order to operate the printer, you must find the source of the problem and fix it.

Troubleshooting

Bed calibration point was not found & Please consult the manual

Both of these error messages point to the same source. The printer was unable to find any of the calibration points. Therefore, there is almost for sure something wrong with the assembly. Don't re-assemble your printer just yet, but see the troubleshooting points of the following articles.

• XYZ calibration troubleshooting
• X/Y/Z各軸の長さの確認 (MK3S)

Left, Right, or Front calibration points not reachable

Unlike the other error messages related to the calibration, in this one, the printer was actually able to find some calibration points, but not all of them. However, troubleshooting remains the same. As that is the only way how to easily find out where the problem lies.

1. Go to LCD Menu -> Calibration -> Auto home. 
2. Inspect where the PINDA sensor ends up. It must be within the First calibration point.
3. After checking the 1st calibration point, move the extruder with your hand, to the other end of the heatbed and inspect the 2nd calibration point. 
4. If the PINDA sensor wasn't inside of any of the circles. Follow the instructions in the PINDA sensor misaligned.