EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

Manual changelog MINI+ kit

Manual changelog MINI+ kit

Manual changelog MINI+ kit
Relevant for:
Last updated 2 years ago
Manual changelog MINI+ kit
 Difficulty
Very easy
 Steps
4
 Available languages
CSPLDEESITFR

Step 1 Version history

Version history
Version history
Versions of the MINI+ kit assembly manual:
01/2021 - Initial version 1.05
02/2021 - Updated to version 1.06
03/2021 - Updated to version 1.07
11/2021 - Updated to version 1.08

Step 2 Changes to the manual (1)

Changes to the manual (1)
Changes to the manual (1)
Changes to the manual (1)
Changes to the manual (1)
02/2021 - YZ-axis assembly
Improved inspection holes to check the insertion of the smooth rods in the MINI-Z-bottom.
02/2021 - X-axis & Extruder assembly
Added inspection holes to check the insertion of the smooth rods in the MINI-X-end.
02/2021 - X-axis & Extruder assembly
The dimension of the gap between the motor and the X-axis pulley has been changed from 2 mm to 0.7 - 1 mm.
Manual version 1.06

Step 3 Changes to the manual (2)

Changes to the manual (2)
Changes to the manual (2)
03/2021 - Print head & Heatbed assembly
Added instruction for firmly tightening screws on heatbed cables.
Manual version 1.07

Step 4 Changes to the manual (3)

Changes to the manual (3)
Changes to the manual (3)
11/2021 - LCD assembly & Electronics
New kit units are shipped with a silver label already affixed to the Z-axis extrusion.
Manual version 1.08
Was this guide helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us