EN
Login- Čeština
- Español
- Italiano
- Deutsch
- Polski
- Français
- Home
- MK3
- Using the printer
- Printer maintenance
- Community translations (MK3/MK3S/MK3S+)
Community translations (MK3/MK3S/MK3S+)
Menu
- Printer maintenance
- How to replace a heatbreak/heaterblock/heatsink (MK3/MK2.5)
- How to replace a hotend thermistor (MK3S/MK3S+)
- How to replace a print fan (MK3S/MK3S+)
- How to replace a hotend (MK3S/MK3S+)
- How to replace an IR-sensor (MK3S/MK3S+)
- How to replace a P.I.N.D.A. sensor (MK3S)
- How to replace SuperPINDA (MK3S/MK3S+)
- How to replace bearings on the Y-axis (MK3S+)
- How to replace bearings on the X-axis (MK3S+)
- How to replace a hotend heater (MK3S/MK3S+)
- How to replace a heatbreak/heatsink/heaterblock (MK3S+/MK3S/MK2.5S/MMU2S)
- How to replace a PTFE tube (MK3/MK2.5)
- How to trim PTFE tube - Multi Material
- How to post-process the printed parts
- How to replace a heatbed thermistor (MK3S+/MK3S/MK2.5S/MK2S)
- How to replace PSU on MK3 printers
- How to replace a hotend PTFE tube (MK3S+/MK3S/MK2.5S/MMU2S)
- How to replace a hotend thermistor (MK2S)
- How to trim PTFE tube - Original Prusa printers
- Maintenance tips
- Replacing the PEI sheet on the (MK3S/MK3/MK2.5S/MK2.5)
Was this guide helpful?
Comments
Still have questions?
If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.