1. Z axis and first layer calibration (optional)
Step 1 of 9 (Chapter 13 of 14)
Contents
Comments
IMPORTANT: This step is necessary only in case you have adjusted the position of the SuperPINDA sensor in the previous chapter. Otherwise, you can skip to the next step and use the Live Adjust Z function as usual to fine-tune the first layer.
⬢Go to LCD Menu - Calibration - Calibrate Z.
⬢Then run the First Layer Calibration.
Contents
Original Prusa i3 to MMU2S upgrade
- 1. Introduction
- 2A. MK3S+ extruder disassembly
- 2B. MK3S/MK2.5S extruder disassembly
- 2C. MK3/MK2.5 extruder disassembly
- 3A. MK3S+ extruder upgrade
- 3B. MK3S/MK2.5S extruder upgrade
- 3C. MK3/MK2.5 extruder upgrade to MK3S/MK2.5S
- 4. Idler body assembly
- 5. Pulley body assembly
- 6. Electronics and MMU2S unit assembly
- 7. Spool holder and buffer assembly
- 8. Preflight check & Calibration
- 9. First flight
- Manual changelog MMU2S
Comments
Log in to post a comment
No comments