1. Tools necessary for this chapter

CORE One conversion kit (1.01)

• 1A. Introduction
• 1B. MK4S Inspection
• 1C. Printer Disassembly
• 1D. Component Prep
• 2. Base assembly
• 3. Back assembly
• 4. Heatbed assembly
• 5. CoreXY assembly
• 6. Nextruder assembly
• 7. Bodywork & Electronics
  1. Tools necessary for this chapter
  2. Front profiles: parts preparation
  3. Installing the front right profile
  4. Installing the front left profile
  5. Top profiles: parts preparation
  6. Assembling the top profiles I.
  7. Assembling the top profiles II.
  8. Aligning the top profiles
  9. Installing the top profiles
  10. CoreXY fixing screws: parts preparation
  11. Fixing the CoreXY assembly
  12. Side sensor base: parts preparation
  13. Assembling the side sensor base
  14. Testing the lever
  15. Installing the magnets
  16. IR Sensor: parts preparation
  17. Connecting the IR sensor
  18. Installing the IR sensor
  19. Installing the side sensor cover
  20. Side filament sensor: parts preparation
  21. Installing the side filament sensor
  22. Guide the filament sensor cable
  23. Connecting the side filament sensor
  24. NFC Antenna: parts preparation
  25. Applying the adhesive film
  26. Installing the NFC Coil
  27. Connecting the NFC Coil
  28. Preparing the electronics cover
  29. Installing the electronics cover
  30. xBuddy cover: parts preparation
  31. Installing the xBuddy cover
  32. Installing the rear cover
  33. Right side: parts preparation
  34. Installing the spool holder
  35. Right handle: parts preparation
  36. Installing the collet
  37. Mounting the handle
  38. Fixing the right side
  39. Left side: parts preparation
  40. Installing the left side
  41. Haribo time
  42. Done
• 8. Trim, Door & xLCD
• 9. Calibration & First run
• Manual changelog