1. Installing the spoolholder: Parts preparation

Bondtech INDX Conversion kit for the Prusa CORE One/+ (Founders Edition) (1.00)

• 1. Introduction
• 2: Printer preparation & disassembly
• 3. Z-axis upgrade
• 4. INDX Toolhead & Side filament sensors
• 5. Spoolholders & Tool dock assembly
• 6. Preflight check
  1. Installing the spoolholder: Parts preparation
  2. Locking the spoolholders
  3. Attaching the print sheet
  4. Firmware update
  5. Turning on the printer
  6. Setting up the printer: Intro
  7. Setting up the printer: Network setup
  8. Wizard: Intro
  9. Wizard: Door sensor calibration
  10. Wizard: Belt tensioning
  11. Wizard: Dock calibration I.
  12. Wizard: Dock calibration II.
  13. Wizard: Dock calibration III.
  14. Wizard: Loadcell Test
  15. Wizard: Fan test
  16. Wizard: Tool offsets calibration
  17. Wizard: Nozzle cleaner calibration
  18. Wizard: Nozzle cleaner calibration Z/X-axis
  19. Wizard: Nozzle cleaner calibration Y-axis
  20. Wizard: Filament sensors calibration
  21. Wizard complete
  22. Securing the top cover
  23. Haribo time!
  24. Prusa knowledge base
  25. Give us feedback
  26. Join Printables!