EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
  • 日本語
Login

6. LCD assembly

6. LCD assembly
Relevant for:
Last updated 3 years ago
6. LCD assembly
 Difficulty
Easy
 Steps
11
 Available languages
CSDEESFRITJAPL

Step 2 Preparing the LCD parts

Preparing the LCD parts
Preparing the LCD parts
For the following steps, please prepare:
LCD-cover (1x)
LCD-knob (1x)
LCD-support (2x)
LCD screen (1x)
M3x10 screw (6x)
M3nS nut (4x)
SD card (1x)

Step 3 Checking the LCD cables

Checking the LCD cables
Checking the LCD cables
Checking the LCD cables
Before you start, please ensure the cables are plugged in the correct order.
To the slot called EXP1 (see the board) must be connected cable with ONE black stripe.
To the slot called EPX2 (see the board) must be connected cable with TWO black stripes.
There is an updated version of the LCD connectors, which are now connected perpendicular (90°) to the board. Functionality remains the same. See the second picture.

Step 4 Assembling the LCD supports

Assembling the LCD supports
Assembling the LCD supports
Assembling the LCD supports
Assembling the LCD supports
Prepare the LCD controller and LCD-support printed part as shown in the picture.
Slide the LCD-support parts on the LCD-controller.
Repeat the steps above for the second support.
Ensure the correct orientation of parts and the LCD controller.
The exact position will be adjusted later, no need to worry at this moment.

Step 5 Assembling the LCD-cover

Assembling the LCD-cover
Assembling the LCD-cover
Assembling the LCD-cover
Press the LCD controller with the LCD-support into the LCD-cover as shown in the picture.
Adjust the position of the supports if needed.
Press it as deep as possible.
The LCD controller must click under support in the centre of the LCD-cover.

Step 8 Mounting the LCD display onto the printer

Mounting the LCD display onto the printer
Mounting the LCD display onto the printer
Mounting the LCD display onto the printer
Mounting the LCD display onto the printer
Locate the holes for M3 screws on the front plate.
Press through four M3x10 screws.
Place the LCD assembly onto the front side of the Y-axis.
Tighten all four screws.

Step 10 LCD is done!

LCD is done!
LCD is done!
That was fast! Wasn't it?
Check the final look, compare it to the picture.
You can now remove the protective foil from the LCD panel.
You can slide the SD card in (from the left side). However, it is recommended to wait till the printer is completed.
Was this guide helpful?
This action is available only to registered users. Please log-in.

Comments

Please sign in before adding a comment.
Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to info@prusa3d.com or through the button below.