1. Attaching the MMU unit (part 1)

Step 1 of 6 (Chapter 4 of 5)

Contents

Comments

⬢The MMU3 unit should be placed onto the top part of the printer's frame.

⬢Place the MMU3 unit onto the frame.

Attach it just by the top hooks.

⬢Look from behind, there are "clamps", which will be used to lock the unit to the frame in the next step.

Original Prusa MK4S with MMU3 (assembled bundle) (1.0)

1. Introduction
2. Cassete Buffer Assembly
3. Spool Holder Assembly
4. Preparing the assembly
5. Preflight check

Comments

Andy

•

Where do I plug the mmu3 in? It is not mentioned

David B.

•

Hi! On the Assembled Bundle version, the MMU is already connected to the printer.

If you are building the kit version, or attaching an assembled unit, you might want to visit this another guide:
https://help.prusa3d.com/guide/10a-mk4-s-mk3-9-s-setup-and-calibration_426826#685398