1. Tools necessary for this chapter

Bondtech INDX Conversion kit for the Prusa CORE One/+ (Founders Edition) (1.00)

• 1. Introduction
• 2: Printer preparation & disassembly
• 3. Z-axis upgrade
• 4. INDX Toolhead & Side filament sensors
  1. Tools necessary for this chapter
  2. Loosening the belts
  3. Releasing the belts
  4. Gantry aligner tool: parts preparation
  5. Installing the Gantry-aligner-tool - right
  6. Installing the Gantry-aligner-tool - left
  7. Aligning the linear rail
  8. Removing the Gantry-aligner-tool
  9. Print head mount: parts preparation
  10. Securing the belts
  11. Installing the Head-mounting-plate
  12. Adjusting the belts
  13. INDX Toolhead assembly: Parts preparation
  14. Attaching the cable strain relief
  15. INDX Toolhead: parts preparation
  16. Mounting the INDX Toolhead
  17. Fan shroud: parts preparation
  18. Attaching the Fan-shroud
  19. Inserting the nut
  20. Print fan: parts preparation
  21. Installing the print fan
  22. Connecting the print fan
  23. INDX head cable: parts preparation I.
  24. INDX head cable: parts preparation II.
  25. Guiding the head cable
  26. Inserting the nylon string
  27. Connecting the head cable
  28. Attaching the head cable
  29. Securing the swing arm clip
  30. Securing the main cable
  31. Installing the Head cable clip
  32. Connecting the head cable: parts preparation
  33. Inserting the zip ties
  34. Connecting the head cable
  35. Securing the cables
  36. Haribo time!
  37. INDX PTFE holders: parts preparation
  38. Installing the PTFE-holder-left
  39. Installing the PTFE-holder-right
  40. Side filament sensors: parts preparation
  41. Inserting the sleeves
  42. Inserting the collets
  43. Installing the magnets
  44. Assembling the FS: parts preparation I
  45. Assembling the FS: parts preparation II
  46. Inserting the steel balls
  47. Attaching the magnets
  48. Assembling the FS-top left
  49. Covering the FS - left
  50. Assembling the FS-top right
  51. Covering the FS - right
  52. PTFE tubes - left side: parts preparation
  53. Preparing the FS - left
  54. Mounting the FS - left
  55. Connecting the PTFE tube - left
  56. PTFE measurement: parts preparation
  57. Attaching the PTFE tubes - left
  58. Measurement info
  59. Inserting the PTFE tubes (position 1,2)
  60. Inserting the PTFE tubes (position 3,4)
  61. PTFE tubes - right side: parts preparation
  62. Preparing the FS - right
  63. Mounting the FS - right
  64. Connecting the PTFE tube - right
  65. Attaching the PTFE tubes - right
  66. Inserting the PTFE tubes (position 8,7)
  67. Inserting the PTFE tubes (position 5,6)
  68. Connecting the filament sensor cable
  69. Haribo time!
  70. Done
• 5. Spoolholders & Tool dock assembly
• 6. Preflight check