English
Login
Prusa Research a.s.
Prusa Research a.s.

1. Tools necessary for this chapter

Step 1 of 65 (Chapter 3 of 5)
Contents
Comments
Needle-nose pliers for zip tie trimming.
2.5mm Allen key for M3 screws
2mm Allen key for nut alignment
1.5mm Allen key for tightening the pulley
Tools necessary for this chapter

Contents

Original Prusa i3 MK3 to MK3S upgrade

Comments

Log in  to post a comment
Spyder99
Could not get the wires to fit in the slot provided. Took a hot knife and removed the tabs. Will see if that works.
Spyder99
That did not work. Can support provided me with the file for the extruder body that I can open in Fusion 360 and make the wire channel wider by removing material from the left side of the channel?
Official Prusa CS
Hi, I'm not sure which part are you referring to. If you need advice, you can always contact us via LiveChat :) https://shop.prusa3d.com/en/
harrysamuel
Yeah this is the worst design nave ever come up with I'm and have to grind off a bolt too. There's a difference between difficult and stupid,  This design is just plain stupid.
Keith Selbo
This section took me 4 hours and 45 minutes. That included a half hour to grind the head off a bolt so I could remove it after the nut I was pulling in with the bolt started spinning in it’s socket. I don’t recommend the Prusa method of pulling a nut into it’s socket with a bolt.