There will be a lot of waste when the project is completed. This is what I do with filament waste: https://www.printables.com/model/922849-3d-waste-to-mobile-art
After the process thoughts (although still waiting for 5 dwarf boards): 1. There are a lot of screws, a cordless driver makes the process much, much easier. And, curved tip tweezers make it easier to hold screws both out and in. 2. Dedicated hex drivers (long) with handles/grips make deep hole screw access easier than default drivers 3. The self locking nut insertions are hard, a Knipex Plier Wrench makes insertion easier 4. A magnetized part holder keeps parts safe and accessible 5. When you use the belt tuner it has to be absolutely quiet. I had to turn off my NAS RAID, my computer and my computer RAID (and asked my partner to stop using her sewing machine) as they all produced 120Hz hum that confused the tuner. 6. For 'belt and suspenders' belt tuning I use a BIQU belt tuner. Using the Prusa belt tuner produces a reading of -5.2 on the BIQU. This is the same reading on the older belts and the newer belts and is +-.2 between both belts. 7. Be sure to look for and read others' comments, many are exceedingly helpful 8. I found most of the belt pulleys/shafts/etc to be quite dirty and required a good deal of scrubbing with I90 alcohol. 9. A small cordless vacuum helps get all of the filament bits out of hard to reach areas when this type of heavy disassembly occurs.
1. There are a lot of screws, a cordless driver makes the process much, much easier. And, curved tip tweezers make it easier to hold screws both out and in.
2. Dedicated hex drivers (long) with handles/grips make deep hole screw access easier than default drivers
3. The self locking nut insertions are hard, a Knipex Plier Wrench makes insertion easier
4. A magnetized part holder keeps parts safe and accessible
5. When you use the belt tuner it has to be absolutely quiet. I had to turn off my NAS RAID, my computer and my computer RAID (and asked my partner to stop using her sewing machine) as they all produced 120Hz hum that confused the tuner.
6. For 'belt and suspenders' belt tuning I use a BIQU belt tuner. Using the Prusa belt tuner produces a reading of -5.2 on the BIQU. This is the same reading on the older belts and the newer belts and is +-.2 between both belts.
7. Be sure to look for and read others' comments, many are exceedingly helpful
8. I found most of the belt pulleys/shafts/etc to be quite dirty and required a good deal of scrubbing with I90 alcohol.
9. A small cordless vacuum helps get all of the filament bits out of hard to reach areas when this type of heavy disassembly occurs.