3. Detaching the Nextruder

3. Detaching the Nextruder
Relevante para :
Ultima actualización 5 months ago
3. Detaching the Nextruder
 Dificultad
Moderada
 Pasos
9
 Idiomas disponibles
EN
Wi-Fi antenna detaching
Wi-Fi antenna detaching
This step is only for the printer, which has a Wi-Fi antenna on the back of the printer.
Turn the printer, so the back side of the printer is facing you.
Unscrew the Wi-Fi antenna from the antenna connector and place it nearby.
PTFE unpluging
PTFE unpluging
Turn the printer so the left side of the printer is facing you.
Gently push the black collet to release the PTFE tube.
Pull out the PTFE tube.
Disconnecting the Nextruder cable
Disconnecting the Nextruder cable
Disconnecting the Nextruder cable
Disconnecting the Nextruder cable
Turn the printer, so the back side of the printer is facing you.
There is an antenna cable behind the antenna-holder, do not pull the connector!
Loosen two screws on the cover slightly. No need to remove them completely. Push the cover to the right and gently remove it from the screws.
Push the safety latch and disconnect the Nextruder cable from the connector "DWARF1".
Attach the antenna-holder to the screws and push the cover to the left. Tighten the screws.
Detaching the dock
Detaching the dock
Detaching the dock
If you have an older version of the CoreXY back cover, untighten the screw in the dock same as the instructions say. The process is the same.
Using a 2.5mm Allen key, untighten the screw inside the (middle hole) dock.
Keep the Nextruder cable bundle next to the printer.
Detaching the Nextruder
Detaching the Nextruder
Detaching the Nextruder
Turn the printer, so the front side is facing you.
Snap off the x-carriage-cover back from the X-carriage. Do not throw it away, we'll use it later!
Using a T10 Torx key, remove two M3x12bT screws.
Detaching the Nextruder
Detaching the Nextruder
Detaching the Nextruder
Hold the Nextruder during disassembly.
Untighten two M3x12bT screws using a T10 Torx key.
Detach the Nextruder and place it nearby, we will rebuilt it in the next steps.
Still no sweets?
Still no sweets?
Please don't open the bag yet.
But you are getting close to your first taste ;).
Good job!
Good job!
Well done! Let's go to the next chapter: 4. ToolChanger assembly
¿Fue útil esta guía?

Comentarios

¿Todavía tienes preguntas?

¿Todavía tienes preguntas?

Si tienes alguna pregunta sobre algo que no se ha tratado aquí, comprueba nuestros recursos adicionales.
Y si eso no lo soluciona, puedes enviar una petición a [email protected] o mediante el botón que hay más abajo.

Contacta con nosotros