English
1. Connecting the extruder cable bundle
Step 1 of 6 (Chapter 5 of 7)
Contents
Comments
⬢Find the slot for the NYLON filament on the Einsy-base. You will need it in the next step.
⬢Before we proceed further, we need to twist the textile sleeve. This will prevent the cables inside to slip out during the printing.
⬢Using your fingers, gently twist the sleeve (not the cables) and create several wraps.
⬢Twisting the sleeve will effectively shorten its length. In the following steps, you might need to untwist the sleeve slightly to elongate it.
Contents
Original Prusa i3 MK3/MK3S to MK3S+ upgrade
- 1. Introduction
- 2A. MK3 Extruder disassembly
- 3A. MK3 Extruder upgrade
- 3B. MK3S Extruder upgrade
- 4. Electronics assembly
- 5. Y-axis upgrade
- 6. Preflight check
Comments
Log in to post a comment
No comments