English
1. Tools necessary for this chapter
Step 1 of 12 (Chapter 3 of 11)
Contents
Comments
⬢2.5mm Allen key for M3 screws
⬢2mm Allen key for nut alignment
Contents
Original Prusa i3 MK3S kit assembly (v3.15)
- 1. Introduction
- 2. Y-axis assembly
- 3. X-axis assembly
- Tools necessary for this chapter
- X-axis: x-end idler and motor holder
- X-axis: inserting linear bearings
- X-end-motor: tensioner assembly
- X-end-idler: bearing assembly
- X-axis: smooth rods preassembly
- X-axis: assembly
- Assembling the X-axis motor pulley (part 1)
- Assembling the X-axis motor pulley (part 2)
- X-axis: assembling the motor
- Haribo time!
- X-axis is finished!
- 4. Z-axis assembly
- 5. E-axis assembly
- 6. LCD assembly
- 7. Heatbed & PSU assembly (Black PSU)
- 7. Heatbed & PSU assembly (Silver PSU)
- 8. Electronics assembly
- 9. Preflight check
- Manual changelog
Comments
Log in to post a comment
Stephen Cooper
•
I don’t see anywhere in this step that zip ties are used. Why are the needle nose pliers mentioned as being needed?
Reply
Martin L. - Official Prusa CS
•
Stephen, you can need them during the manupulation with the bearings, as well as for insterting nuts into their traps.
Reply