What happened? The printer will display "Mintemp error" for the heatbed if the printer's heatbed temperature goes below 15 ºC at any point. In this case, the printer will stop the ...
What happened? While flashing firmware to your printer an error might occur, and the screen will display the following message: "Firmware in the internal flash corrupted!". The system inside the printer ...
What happened? The Main Control Unit on the MMU control board has detected a power-related issue. How to fix it? Verify all the cables are in good condition and all the connections are ...
What happened? During the configuration of Prusa Connect on the Original Prusa MINI/+, MK4/S, MK3.9/S, MK3.5/S or XL an error on this configuration can occur and the printer shows the message ...
What happened? The Original Prusa MK4S/MK4/MK3.9/MK3.5 displays the message: "Failed to home the extruder in X-axis, make sure there is no obstacle on X-axis". Error name: Homing error X Error code: #26304 (MK4S) ...
What happened? While loading to the extruder, as soon as the filament sensor detects a filament the printer performs an automatic loading check. If the check fails, this error is shown. ...
What happened? Before it can align with any of the filament positions, the Idler inside the MMU unit needs to be “homed” to determine its position. First, the Idler moves to ...
What happened? During the configuration of Prusa Connect on the Original Prusa MK4 and MK4S, an error on this configuration can occur and the printer shows the message "Registration to Prusa ...
This is an advanced system for displaying error screens, providing more useful information to the user. In case of an issue, the printer will display the name of the error ...
What happened? While the MMU unit was unloading a filament, the SuperFINDA sensor inside the selector stayed triggered/detecting a filament, while it shouldn’t. The superFINDA might be referred to as FINDA on ...
If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.