JA
  • English
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

MMU1のフィラメントプーリー

MMU1のフィラメントプーリー

MMU1のフィラメントプーリー
Relevant for:
Last updated 9 months ago
MMU1のフィラメントプーリー
 Difficulty
Moderate
 Steps
4
 Available languages
ENCSPLESDEITFR
アイドラーネジの取り外し
アイドラーネジの取り外し
アイドラーネジの取り外し
両方のアイドラーネジを取り外します。
Ensure that idler can move freely on screw, if not the case slightly loose screw holding idler in place.
Be aware of M3nS nuts for idler screws as they can fall from slots.
プーリーの位置
プーリーの位置
Make sure milled slot on motor mounted pulley is perfectly in center with filament.
Make sure grub screw is tight and pulley is secured in place.
元通りに組み立て
元通りに組み立て
After you're done, assemble the idler back together.
Tighten the screws, the gap between washer and idler (printed part) should be 4-5 mm.
This photo is just for illustration, you don't have to remove the extruder from the printer.
Was this guide helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us