1. Belt tensioning

Prusa CORE One+ キットの組み立て

• 1. Introduction
• 2. Base assembly
• 3. Back assembly
• 4. Heatbed assembly
• 5. CoreXY assembly
• 6. Nextruder assembly
• 7. ボディワーク & 電子部品
• 8. Trim, Door & xLCD
• 9. キャリブレーションとファーストラン
  1. Belt tensioning
  2. Installing the spoolholder: Parts preparation
  3. Attaching the print sheet and spoolholder
  4. Firmware update
  5. Turning on the printer
  6. プリンターの設定：はじめに
  7. Setting up the printer: Network setup
  8. Wizard: Intro
  9. Wizard: Door Sensor Calibration
  10. Wizard: Loadcell Test
  11. Wizard: Gearbox Alignment
  12. Wizard: Filament Sensor Calibration
  13. Wizard complete
  14. Haribo time
  15. Handbook
  16. Prusa knowledge base
  17. Join Printables!
• Manual changelog