1. Tools necessary for this chapter

Original Prusa XL Single-head to Five-head upgrade [進行中の翻訳] (1.01)

• 1. Introduction
• 2. Printer preparing
• 3. Detaching the Nextruder
• 4. ToolChanger assembly
• 5. Nextruder upgrade
• 6. PSU & electronics assembly [進行中の翻訳]
  1. Tools necessary for this chapter
  2. Back antenna disconnecting
  3. Back antenna disassembly
  4. Back covers disassembly
  5. PSU assembly: parts preparation
  6. PSU assembly: PSU preparing
  7. PSU assembly: PSU preparing
  8. PSU assembly: printer preparing
  9. Attaching the PSU
  10. Securing the PSU
  11. PSU covers: parts preparations
  12. PSU covers: side cover
  13. PSU covers: lower cover
  14. PSU power cable cover: parts preparation
  15. PSU power cable cover: lower cover
  16. PSU power cable cover: power cable
  17. PSU power cable cover: middle cover
  18. PSU power cable cover: upper cover
  19. XL-splitter: parts preparation
  20. XL_splitter installation
  21. Filament sensor cable: parts preparation
  22. Filament sensor cable: connecting the cable
  23. Metal plate cable covers: parts preparations
  24. Adjusting the XL-buddy-box-cover
  25. Lower metal plate cable covers
  26. Upper metal plate cable covers
  27. XL buddy cover
  28. Reward yourself!
  29. Well done!
• 7. Nextruder & accessories assembly
• 8. First run
• Manual changelog XL (Single-head to Five-head upgrade)