1. Tools necessary for this chapter

Prusa INDX Conversion kit for the Prusa CORE One/+ [進行中の翻訳] (1.00)

• 1. Introduction
• 2. Printer preparation & disassembly
• 3. Z-axis upgrade
• 4. INDX Toolhead & Side filament sensors [進行中の翻訳]
  1. Tools necessary for this chapter
  2. Loosening the belts
  3. Releasing the belts
  4. Gantry aligner tool: parts preparation
  5. Installing the Gantry-aligner-tool - right
  6. Installing the Gantry-aligner-tool - left
  7. リニアレールの位置合わせ
  8. Removing the Gantry-aligner-tool
  9. Toolhead mount: parts preparation
  10. Securing the belts
  11. Installing the Head-mounting-plate
  12. Lubricating the belt tensioner screw
  13. Adjusting the belts
  14. INDX Toolhead assembly: Parts preparation
  15. Attaching the head cable cover front
  16. INDX Toolhead: parts preparation
  17. Mounting the INDX Toolhead
  18. Fan shroud: parts preparation
  19. Attaching the Fan-shroud
  20. Inserting the nut
  21. プリントファン: 部品の準備
  22. Installing the print fan
  23. プリントファンの接続
  24. INDX head cable: parts preparation I.
  25. INDX head cable: parts preparation II.
  26. Guiding the head cable
  27. Inserting the nylon string
  28. Connecting the head cable
  29. Attaching the head cable
  30. Securing the swing arm clip
  31. Securing the head cable
  32. Installing the Head cable clip
  33. Connecting the head cable: parts preparation
  34. Inserting the zip ties
  35. Connecting the head cable
  36. Securing the cables
  37. Haribo time!
  38. INDX PTFE holders: parts preparation
  39. Installing the PTFE-holder-left
  40. Installing the PTFE-holder-right
  41. Side filament sensors: parts preparation
  42. Inserting the sleeves
  43. Inserting the collets
  44. Installing the magnets
  45. Assembling the FS: parts preparation I
  46. Assembling the FS: parts preparation II
  47. Inserting the steel balls
  48. Attaching the magnets
  49. Assembling the FS-top left
  50. Covering the FS - left
  51. Assembling the FS-top right
  52. Covering the FS - right
  53. PTFE tubes - left side: parts preparation
  54. Preparing the FS - left
  55. Mounting the FS - left
  56. Connecting the PTFE tube - left
  57. PTFE measurement: parts preparation
  58. Attaching the PTFE tubes - left
  59. Measurement info
  60. Inserting the PTFE tubes (position 1,2)
  61. Inserting the PTFE tubes (position 3,4)
  62. PTFE tubes - right side: parts preparation
  63. Preparing the FS - right
  64. Mounting the FS - right
  65. Connecting the PTFE tube - right
  66. Attaching the PTFE tubes - right
  67. Inserting the PTFE tubes (position 8,7)
  68. Inserting the PTFE tubes (position 5,6)
  69. Connecting the filament sensor cable
  70. Haribo time!
  71. Done
• 5. Spoolholders & Tool dock assembly
• 6. Preflight check