1. Tools necessary for this chapter

Original Prusa i3 MK3 to MK3S+ upgrade [進行中の翻訳]

• 1. Introduction
• 2A. MK3 Extruder disassembly
• 3A. MK3 Extruder upgrade
• 3B. MK3S Extruder upgrade [進行中の翻訳]
  1. Tools necessary for this chapter
  2. はじめる前の注意事項
  3. Extruder-body parts preparation
  4. Extruder-body parts preparation
  5. Extruder-body assembly
  6. FS-lever assembly
  7. Steel ball assembly
  8. エクストルーダーモーター部品の準備
  9. Extruder motor assembly
  10. Guiding the IR-sensor cable
  11. Extruder-body assembly - parts preparation
  12. Extruder-body assembly
  13. Extruder-body assembly
  14. Filament alignment check
  15. Extruder-idler parts preparation
  16. Bearing assembly
  17. Extruder-idler assembly
  18. Extruder-idler mounting
  19. Extruder-cover part preparation
  20. Extruder-cover part preparation
  21. Extruder-cover assembly
  22. Pretensioning the Extruder-idler
  23. Hotend fan assembly - parts preparation
  24. Hotend fan assembly
  25. Hotend fan assembly
  26. Fan-shroud parts preparation
  27. Fan-shroud assembly
  28. プリントファンの準備
  29. Print fan assembly
  30. SuperPINDA センサー 部品の準備
  31. SuperPINDA sensor assembly
  32. ナイロンフィラメントを準備する
  33. Nylon guide assembly
  34. IR-sensor - parts preparation
  35. IR-sensor assembly
  36. X-carriage-back assembly
  37. Mounting the X-carriage-back
  38. ケーブルスリーブを取り付ける
  39. ケーブルスリーブを取り付ける
  40. E-axis is finished!
• 4. Electronics assembly
• 5. Y-axis upgrade
• 6. Preflight check