1. Tools necessary for this chapter

Bondtech INDX Upgrade for the Prusa CORE One+ [進行中の翻訳] (1.00)

• 1. はじめに
• 2: Printer preparation & disassembly
• 3. Z-axis upgrade [進行中の翻訳]
  1. Tools necessary for this chapter
  2. Optional: Installing the Buddy3D Camera USB-C cable
  3. ヒートベッドケーブルカバーを取り外します。
  4. Releasing the heatbed
  5. Removing the heatbed
  6. Removing the bed spacer
  7. Heatbed spacers: parts preparation
  8. Assembling the INDX-bed-spacer-rear
  9. Mounting the INDX-bed-spacer-rear
  10. Inserting the spacer - left
  11. Securing the bed spacer - left
  12. Inserting the spacer - right
  13. Securing the bed spacer - right
  14. Offset sensor: parts preparation
  15. Mounting the INDX offset sensor
  16. Connecting the offset sensor cable
  17. Securing the offset sensor assembly
  18. Guiding the offset sensor cable
  19. Securing the offset sensor cable
  20. Removing the Bed-cable-cover-bottom
  21. Heatbed cable covers: parts preparation I.
  22. Heatbed cable covers: parts preparation II
  23. Assembling the Bed-cable-cover-bottom
  24. Inserting the heatbed
  25. Securing the heatbed
  26. ヒートベッドケーブルをまとめる
  27. ヒートベッドケーブルのカバー
  28. Guiding the heatbed cable bundle I.
  29. Guiding the heatbed cable bundle II.
  30. ケーブルスリーブを固定します。
  31. Removing the Bed-stop-rear
  32. INDX-C1-Bed-stop-rear: parts preparation
  33. Assembling the Bed-stop-rear
  34. Installing the new Bed-stop-rear
  35. Securing the Bed-stop-rear
  36. Connecting the RGB LED + offset sensor cables
  37. ヒートベッドケーブルの接続
  38. Haribo time
  39. Done
• 4. INDX Toolhead & Side filament sensors
• 5. Spoolholders & Tool dock assembly
• 6. Preflight check