JA
  • English
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

2. Printer preparing

2. Printer preparing
Relevant for:
Last updated 8 months ago
2. Printer preparing
 Difficulty
Very easy
 Steps
5
 Available languages
ENCSPLDEESITFR
Preparing the printer
Preparing the printer
Preparing the printer
Preparing the printer
If you have loaded the filament, unload it from the hotend. On the screen, navigate to Filament -> Unload Filament.
Remove the filament from the hotend. It is is necessary to completely remove it from the printer.
WARNING: The hotend and heatbed are very HOT. Do not touch these parts!!!
Move the Z-axis down. On the screen, navigate to Control -> Move axis -> Move Z.
Cool down the printer. On the screen, navigate to Preheat -> Cooldown.
Wait until the hot parts are cooled down to ambient temperature. It takes approximately 10 minutes.
Protecting the heatbed
Protecting the heatbed
Before you proceed, it is recommended to protect the heatbed.
Make sure the heatbed is cooled down to ambient temperature. Place the empty cardboard box approximately to the front center part of the heatbed.
Printer unpluging
Printer unpluging
From the rear side of the printer, turn the power switch OFF (symbol "O").
Unplug the PSU cable.
ハリボーを開けてもいい?
ハリボーを開けてもいい?
ハリボの袋は、とりあえずまだ閉じておきましょう!
そのはやる気持ちは主にプリンタの組み立てに使いましょう。開くように指示されるまで待ってください。
Let's get started
Let's get started
Everything checked? So, let's start with disassembling the printer. Let's go to the next chapter: 3. Nextruder detaching
Was this guide helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us