1. Tools necessary for this chapter

Prusa CORE One+ コンバージョンキット

• 1A. Introduction
• 1B. MK4S Inspection
• 1C. Printer Disassembly
• 1D. Component Prep
• 2. Base assembly [進行中の翻訳]
  1. Tools necessary for this chapter
  2. Base assembly: parts preparation
  3. Inserting the zip ties
  4. Base assembly: parts preparation
  5. Installing the motor mounts
  6. Installing the rear motor
  7. Securing the rear motor
  8. Installing the front motor right
  9. Installing the front motor left
  10. Bottom frame: parts preparation
  11. Assembling the bottom profile: front + left
  12. Assembling the bottom profile: left + rear
  13. Assembling the bottom profile: right
  14. Inserting the spacer pins
  15. Anti-vibration feet: parts preparation
  16. Installing the anti-vibration feet
  17. Installing the bottom frame
  18. Mounting the bottom frame: right side
  19. Mounting the bottom frame: rear + left + front
  20. Haribo time
  21. Done
• 3. Back assembly
• 4. Heatbed assembly
• 5. CoreXY assembly
• 6. Nextruder assembly
• 7. Bodywork & Electronics
• 8. Trim, Door & xLCD
• 9. Calibration & First run
• Manual changelog