What happened?
The printer is showing the message "The bed doesn't seem to be aligned properly. Run Z alignment procedure?" before printing.
Error name: Uneven bed
Error code: #31111
This message is shown when different parts of the print surface are not aligned with each other.
How to fix it?
Go to the printer menu to Control -> Calibrations & tests -> Z alignment calibration. After the calibration, the printer will ask if you wish to finish the tests, click on Quit.
If the issue persists, move the bed down, open the trapezoid nuts, and check if they can move freely along the threaded rods.
It is also possible to lubricate the Z-axis lead screws as instructed in Regular printer maintenance (CORE One) [進行中の翻訳] under "Axes check - Z-axis leadscrews"
 |  |  |
| Rear motor | Front left motor | Front right motor |