English

1. Tools necessary for this chapter

Step 1 of 18 (Chapter 4 of 18)

Contents

Comments

⬢Please prepare tools for this chapter:

⬢Needle-nose pliers

⬢1.5mm Allen key for possible nut alignment

⬢2mm Allen key for M4 grub screws

⬢2.5mm Allen key for M3 screws

MMU3 Assembly (MK3S+, MK3.5, MK3.9/S, MK4/S, CORE)

1. Introduction
2. MMU2S Disassembly (UPG)
3. MMU2S Buffer Disassembly (UPG)
4. Idler Body Assembly
5. Selector Assembly
6. Pulley Body Assembly
7. Spool holder Assembly
8A. Cassette Buffer Assembly
8B. CORE One Buffer Assembly
9A. MK4/S, MK3.9/S Nextruder mod
9B. MK3S+ / MK3.5 Extruder mod (KIT)
9C. MK3S+ Extruder (UPG)
9D. CORE One Nextruder mod
10A. MK4/S, MK3.9/S Setup and Calibration
10B. MK3S+ Setup and Calibration
10C. MK3.5 Setup and Calibration
10D. CORE One Setup and Calibration
11. First Flight

Comments

ventrue3000

•

Before you begin, scroll down to the spool holder section. If you are missing the PTFE holders, print them now. If you wait until that step, you'll have to pause, because the next step after that has you dissassemble the Nextruder.

Baddan

•

Thanks ventrue, It really helped me!
I won´t print the buffer, because I'll use the RMU instead

Orthonormal

•

The PTFE clips are not needed until section 7, the buffer spool assembly, which is when you need all the other printed parts that are printed in the same batch with the PTFE clips.
So for anybody wondering about this, don't worry.

Orthonormal

•

There is no spool holder section on this page to scroll to, and no mention of PTFE holders. I expect that I will eventually need all the printed parts, and am printing each gcode file in the order the parts are needed. After the Unit2 file, I will need Unit1 before anything else, just to finish the steps in this section.
Your comment sent me on a fruitless search.