1. Print Sheet
Paso 1 de 7 (Capítulo 5 de 5)
Contenidos
Comentarios
⬢Reinstall the print sheet.
Make sure there is nothing on the heatbed. The heatbed must be clean. Any dirt can damage the surface of both the heatbed and the print sheet.
⬢Attach the sheet by first aligning the rear cutout with the locking pins on the back of the heated bed. Hold the sheet by the front two corners and slowly lay it down onto the heated bed - watch your fingers!
⬢Keep the print sheet clean for optimum performance.
⬢#1 cause of prints detaching from the print surface is a greasy print sheet. Use IPA (Isopropyl alcohol) to degrease it if you have touched its surface before.
Contenidos
Prusa CORE One+ to Gen 2 upgrade [Traducción en desarrollo]
- 1. Introduction
- 2. Printer disassembly
- 3. Belts upgrade
- 4. Heatbed upgrade
- 5. Preflight check [Traducción en desarrollo]
Comentarios
Inicia sesión para publicar un comentario
Sin comentarios