Tiskový ventilátor

Failing Z calibration (MK3S/MK2.5S)

The size of the extruder and the length of travel of the Z-axis is coded into the firmware. Therefore, if the assembly of the extruder, or the firmware for your extruder, is not…

How to replace a heatbreak/heaterblock/heatsink (MK3/MK2.5)

Err: PRINT FAN ERROR

PRINT FAN ERROR error message occurs when the print fan (the one at the front of the extruder) does not receive any RPM (Revolutions per Minute) readings. This can be caused by…

How to replace a print fan (MK4 / MK3.9)

Print fan is not spinning

The print fan is the fan blowing on the printed object, right below the nozzle. Depending on the material and where you are in the print it might not always spin at full speed…

Err: PRINT FAN ERROR

PRINT FAN ERROR error message occurs when the print fan (the one at the front of the extruder) does not receive any RPM (Revolutions per Minute) readings. This can be caused by…