This article covers how to configure your own image for any Raspberry Pi (RPi) from scratch. Following this article, you will have connected a base installation of Octoprint which…
The Prusa FFF printers are equipped with a brass nozzle. This article will review the main information about the nozzles that can be used with your printer. Brass has excellent…
The Original Prusa MK2.5/S, MK3/S/+, and MK3.5/S use the E3D V6 Hotend. Any nozzle that is compatible with the E3D V6 Hotend can be installed on it. The stock nozzle that accompanies…
Raspberry Pi Zero W has no 5GHz Wi-Fi (only 2.4GHz), and a somewhat weak processor. It does not support using a large amount of Octoprint-plugins or streaming of video and is not…
This article will guide you through the replacement of the nozzle on your Original Prusa MINI printer. Note that this requires you to have some tools available and also be careful…
ATTENTION: Don't copy/paste the information below, always link to this article. The information is subject to change. About the Prusa Face Shield The 3D-printable face shield is…
Octoprint is an open-source system for remotely controlling and monitor your printer. Start/stop/pause prints, change printing temperatures and settings while printing, stream…
