1. Get the necessary tools

Assemblage du kit Original Prusa i3 MK2

• 1. Introduction
• 2. Y-axis assembly
• 3. X-axis assembly
• 4. Z-axis assembly [Traduction en cours]
  1. Get the necessary tools
  2. 3D printed parts
  3. Screw Z-axis-bottom parts to the frame
  4. Placing the Z-screw covers
  5. Placing the Z-motors
  6. Tighten the Z-motors
  7. Placing trapezoid motor nuts
  8. Tighten trapezoid motor nuts
  9. Identifying rod length
  10. Preparing the Z-rods
  11. Assembling the X-axis
  12. Placing the Z-axis-top parts
  13. Cable management
  14. Cleaning up
  15. Assembling the Y-axis
  16. Assembling the X-axis belt part 1
  17. Assembling the X-axis belt part 2
  18. X-axis belt idler guide
  19. X-axis belt carriage guide
  20. X-axis belt motor guide
  21. Loosening the motor
  22. Tightening the X-axis belt part 1
  23. Tightening the X-axis belt part 2
  24. Tensioning the belt
  25. VIDEO for steps 16-24
  26. Adjusting tension screws
  27. All done!
• 5. Extruder Assembly
• 6. LCD assembly
• 7. PSU & Heatbed assembly
• 8. Electronics assembly
• 9. Preflight check