1. Tools necessary for this chapter

Prusa CORE One+ (Gen 2) conversion kit [Traduction en cours] (1.00)

• 1A. Introduction
• 1B. Inspection de la MK4S
• 1C. Démontage de l'imprimante
• 1D. Préparation des composants
• 2. Assemblage de la base
• 3. Assemblage de l'arrière
• 4. Assemblage du plateau chauffant
  1. Tools necessary for this chapter
  2. Heatbed: parts preparation
  3. Heatbed cable assembly (part 1)
  4. Heatbed cable assembly (part 2)
  5. Bed-cable-cover-bottom: parts preparation
  6. Attaching the cable cover
  7. Heatbed carriage: parts preparation
  8. Installing the expansion joint screws
  9. Installing the expansion joints
  10. RGB LED strip: parts preparation
  11. Installing the LED strip
  12. Attaching the LED strip diffuser
  13. Covering the RGB LED strip
  14. Guiding the RGB LED strip cable
  15. Bed mounts: parts preparation
  16. Assembling the bed mounts
  17. Securing the bed mounts
  18. Bed mounts: inserting the nuts
  19. Assembling the CORE-One-bed-spacer-rear
  20. Installing the bed-mount-right
  21. Installing the bed-mount-left
  22. Mounting the heatbed: parts preparation
  23. Securing the heatbed
  24. Expansion joint aligner
  25. Aligning the front side expansion joint
  26. Aligning the front left expansion joint
  27. Aligning the left side expansion joint
  28. Aligning the rear left expansion joint
  29. Aligning the middle rear expansion joint
  30. Aligning the rear right expansion joint
  31. Aligning the right side expansion joint
  32. Aligning the front right expansion joint
  33. Fixing the heatbed
  34. Covering the cables: parts preparation
  35. Guiding the heatbed cables
  36. Covering the heatbed cables
  37. Nozzle wiper assembly: parts preparation
  38. Assembling the nozzle wiper
  39. Mounting the nozzle wiper
  40. Sticking the wiper pad
  41. Mounting the heatbed: parts preparation
  42. Attaching the heatbed assembly
  43. Mounting the heatbed assembly: rear motor
  44. Mounting the heatbed assembly: front motor left
  45. Mounting the heatbed assembly: front motor right
  46. Attaching the heatbed cables I.
  47. Attaching the heatbed cables II.
  48. Securing the heatbed cables: parts preparation
  49. Securing the textile sleeve
  50. Guiding the heatbed assembly cables
  51. Connecting the heatbed power cables
  52. Haribo time
  53. Done
• 5. Assemblage du CoreXY
• 6. Assemblage du Nextruder
• 7. Bodywork & Electronics
• 8. Trim, Door & xLCD
• 9. Calibration & First run