⬢Versions of the SL1 manual:
⬢07/2019 - Initial version 1.00
⬢08/2019 - Updated to version 1.01
⬢10/2019 - Updated to version 1.02
EN
Login- Čeština
- Español
- Italiano
- Deutsch
- Polski
- Français
- 日本語
- Home
- SL1
- Assembly manuals
- Original Prusa SL1 kit assembly
- Manual changelog SL1
Manual changelog SL1
Menu
- Original Prusa SL1 kit assembly
- 1. Introduction
- 2. Base & Tower
- 3. Covers & Platform
- 4. Electronics & Lid
- 5. Preflight check
- Manual changelog SL1
- 1. Versions history
- 2. Changes to the manual (1)
- 3. Changes to the manual (2)
Manual changelog SL1
Relevant for:
Last updated 5 years ago Difficulty
Moderate Steps
3 Available languages
⬢08/2019 - 2. Base & Tower
⬢Assembly procedure of the reflector adjusted for easier installation.
⬢New blower fan holder added. The assembly procedure adjusted accordingly.
⬢08/2019 - 4. Electronics & Lid
⬢A new cable for powering the UV LED added, same properties as the old version, just different manufacturing method.
⬢Removal of the protective film from the reflector moved just before the print display installation.
Manual version 1.01
⬢09/2019 - 2. Base & Tower
⬢New M4w washer added to further improve the grounding between the parts.
⬢New revision of the Optical IR-sensor introduced. Functionality is the same. The assembly procedure remains the same as well.
⬢New revision of the Connecting rod introduced. The difference in the manufacturing process, assembly is the same.
⬢Added instructions regarding ESD safety to protect the electronics.
Manual version 1.02
Was this guide helpful?
Comments
Still have questions?
If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.