JA
  • English
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

Filament pulleys MMU1

Filament pulleys MMU1
Relevant for:
Last updated 3 years ago
Filament pulleys MMU1
 Difficulty
Moderate
 Steps
4
 Available languages
CSDEENESFRITPL

Step 1 Removing idler screws

Removing idler screws
Removing idler screws
Removing idler screws
Remove both idlers screws.
Ensure that idler can move freely on screw, if not the case slightly loose screw holding idler in place.
Be aware of M3nS nuts for idler screws as they can fall from slots.

Step 3 Pulley position

Pulley position
Pulley position
Make sure milled slot on motor mounted pulley is perfectly in center with filament.
Make sure grub screw is tight and pulley is secured in place.

Step 4 Assembling back together

Assembling back together
Assembling back together
After you're done, assemble the idler back together.
Tighten the screws, the gap between washer and idler (printed part) should be 4-5 mm.
This photo is just for illustration, you don't have to remove the extruder from the printer.
Was this guide helpful?

Comments

Please sign in before adding a comment.
Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to info@prusa3d.com or through the button below.