1. Iniziare il montaggio

Manutenzione della stampante

• Come installare l'adattatore Ugello Nextruder V6 (CORE One L)
• How to replace the Prusa Nozzle (CORE One L)
• Come sostituire un gruppo hotend (CORE One L)
• How to replace the hotend fan (CORE One L)
• How to replace the side filament sensor (CORE One L)
• How to install the advanced filtration (CORE One L)
• How to replace a Hotend Heater (CORE One L)
• How to replace a Hotend Thermistor (CORE One L)
• How to replace Nextruder Filament Sensor (CORE One L)
• How to replace the print fan (CORE One L)
• How to replace the Accelerometer (CORE One L)
• How to replace Hotend Heatsink (CORE One L)
• How to reverse the door orientation (CORE One L) [Traduzione in corso]
  1. Iniziare il montaggio
  2. Introduction
  3. Tools necessary for this chapter
  4. Removing the door panel
  5. Removing the hinges
  6. Magnet holders: parts preparation
  7. Installing the door magnets
  8. Door hinges: parts preparation
  9. Installing the inner hinges
  10. Installing the outer hinges
  11. Door panel: parts preparation
  12. Mounting the door panel
  13. Well done!
• How to replace Loveboard (CORE One L)
• How to replace a Hotend Thermistor (CORE One L)