EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

Manual changelog MINI+ kit

Manual changelog MINI+ kit

Manual changelog MINI+ kit
Relevant for:
Last updated 10 months ago
Manual changelog MINI+ kit
 Difficulty
Very easy
 Steps
5
 Available languages
CSPLDEESITFR
Version history
Version history
Versions of the MINI+ kit assembly manual:
01/2021 - Initial version 1.05
02/2021 - Updated to version 1.06
03/2021 - Updated to version 1.07
11/2021 - Updated to version 1.08
05/2023 - Updated to version 1.09
Changes to the manual (1)
Changes to the manual (1)
Changes to the manual (1)
Changes to the manual (1)
02/2021 - YZ-axis assembly
Improved inspection holes to check the insertion of the smooth rods in the MINI-Z-bottom.
02/2021 - X-axis & Extruder assembly
Added inspection holes to check the insertion of the smooth rods in the MINI-X-end.
02/2021 - X-axis & Extruder assembly
The dimension of the gap between the motor and the X-axis pulley has been changed from 2 mm to 0.7 - 1 mm.
Manual version 1.06
Changes to the manual (2)
Changes to the manual (2)
03/2021 - Print head & Heatbed assembly
Added instruction for firmly tightening screws on heatbed cables.
Manual version 1.07
Changes to the manual (3)
Changes to the manual (3)
11/2021 - LCD assembly & Electronics
New kit units are shipped with a silver label already affixed to the Z-axis extrusion.
Manual version 1.08
Changes to the manual (4)
Changes to the manual (4)
05/2023 - Spool holder assembly
Added instructions for assembling the new version of the Spool holder (injection molded).
Manual version 1.09
Was this guide helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us