ATTENTION: proceed very carefully during this step. Use reasonable force and don't rotate the printer. We need to adjust part of the frame, which might affect the overall geometry.
The new black PSU has mounting points in a different place, we need to rotate the short extrusion by 90 °.
⬢Start by releasing and removing M5 screws on both sides of this extrusion. Together you need to remove 8 screws. Note that four screws aren't visible in the picture (green arrows).
Before you close the box, triple check your cables! Have you used the proper polarity? Are all the cables properly tightened?
⬢All checked? OK, close the door, take the M3x40 screw and tighten it.
⬢プリンターのプラグを差し込み、電源を入れます。
⬢Since we were rocking with the printer, run Z-axis calibration from the menu.
In case of issues with the print quality, check the frame geometry and rerun XYZ calibration.
⬢Our work is done here! Good job ;)
Was this guide helpful?
Comments
Still have questions?
If you have a question about something that isn't covered here, check out our additional resources. And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.
