Bed/ Heater wiring

Updated 4 months ago ​by Tomáš Chvalina

Just like in the Thermistor/ Heater article. Your printer suspects that one of your components do not work properly. 

What to do when the error occurs 

It is unlikely that you would have your Thermistor/ Heater improperly plugged. As it would have already been triggered with our other safety mechanism. Yet we still suggest to go over your MK2/MK2S Electronics Wiring to double check that you have everything plugged in properly. 

If everything is plugged in properly. Then please  Make sure that your Heated bed thermistor is properly seated under the Golden kapton tape.

Do not hesitate to contact us at info@prusa3d.com if you would have any following questions.


How did we do?