IT
  • English
Login

Pressure equalizer 

Ultimo aggiornamento 5 months ago
Questo articolo è disponibile anche nelle seguenti lingue: 
EN
This feature is only available in PrusaSlicer 2.5 and newer.

3D printer extruders love to extrude at a constant rate for the best extrusion consistency. However, during a print, the extrusion is typically not constant at all. Inifill is usually printed the fastest, perimeters are printed slower and the external perimeter is printed the slowest for the best surface finish and accurate dimensions. Bowden style extruders are especially sensitive to pressure fluctuations, due to the slack in bowden tube, they are not able to reproduce rapid changes in extrusion rate reliably. 

The Pressure equalizer smooths sudden changes in speed between two features (e.g. between printing infill and perimeters).

You can find the Pressure equalizer settings in Print settings - Speed.

The acceleration limit from lower to higher speed (speed up) is called Max volumetric slope positive.

The acceleration limit when going from higher to lower speed (slow down) is called Max volumetric slope negative. 

The lower the volumetric sloper value is, the smoother will the transition be. Adding these speed transition will likely increase the print time a little bit. Slowing down infill after perimeter may increase print times excessively, this can be suppressed by setting Max volumetric slope positive to zero.

We suggest using values between 2-10.

The internal perimeter is printed at a lower speed in the last segment before transitioning to the external perimeter. The infill is slowed down before transitioning to printing perimeters again.
The print on the right shows bulges on external perimeters due to excess extruder pressure on a Bowden style printer, while the bulges are mitigated in the left print thanks to the pressure equalizer.
The Pressure equalizer does not need any special firmware changes and should work on essentially all FDM 3D printers.

Linear Advance vs Pressure Equalizer 

The Linear Advance algorithm predicts the pressure build-up in the extruder when printing at higher speeds. The firmware of the printer uses that prediction to decrease the amount of filament extruded just before stopping and decelerating, which prevents blobs or artifacts at the sharp corners. In short, it affects extrusion.

The Pressure equalizer smooths the speed changes when transitioning from printing one feature (e.g. infill, perimeters) to another. In short, it affects print speed.

Both of these features can work together to achieve the same end result - smooth and accurate prints with minimal artifacts. In a way, the Pressure equalizer can make the job of Linear Advance easier, but reducing the number of sudden fast movements.

 

Questo articolo è stato utile?

Commenti

Devi aver effettuato l'accesso prima di aggiungere un commento.
0
Hai ancora delle domande?

Hai ancora delle domande?

Se hai una domanda su qualcosa che non è trattato qui, dai un'occhiata alle nostre risorse aggiuntive.
E se questo non dovesse funzionare, è possibile inviare una richiesta a info@prusa3d.com o tramite il pulsante qui sotto.