⬢Remove Festo fittings from multiplexer.
Use the 8mm side of the wrench, which is part of the upgrade kit.
EN
Login- Čeština
- Español
- Italiano
- Deutsch
- Polski
- Français
- 日本語
Multiplexer
Menu
Multiplexer
Relevant for:
Last updated 5 years ago Difficulty
Moderate Steps
3 Available languages
⬢Using piece of filament make sure filament can pass into the PTFE tube without any resistance.
You should be able to freely insert at least 60 mm of filament.
⬢Check all 4 entries.
⬢Check entry of PTFE tube, tube must be without any damage and entry side must have tapered entry.
Was this guide helpful?
Comments
Still have questions?
If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.