1. Tools necessary for this chapter

Prusa CORE One conversion kit

• 1A. Introduction
• 1B. MK4S Inspection
• 1C. Printer Disassembly
• 1D. Component Prep
• 2. Base assembly
• 3. Back assembly
• 4. Heatbed assembly
• 5. CoreXY assembly
• 6. Nextruder assembly
• 7. Bodywork & Electronics
• 8. Trim, Door & xLCD
  1. Tools necessary for this chapter
  2. Top cover: parts preparation
  3. Removing the foil
  4. Test-fitting the top cover
  5. Assembling the top cover I.
  6. Assembling the top cover II.
  7. Testing the ventilation
  8. Installing the top cover
  9. Side covers: parts preparation
  10. Removing the foil
  11. Covering the left side
  12. Covering the right side
  13. xLCD version info
  14. xLCD: parts preparation (A)
  15. Assembling the xLCD I. (A)
  16. Assembling the xLCD II. (A)
  17. Installing the FE Faston connector (A)
  18. xLCD (B): parts preparation (Part 1.)
  19. xLCD (B): parts preparation (Part 2.)
  20. Assembling the xLCD front cover (B)
  21. Covering the xLCD (B)
  22. Installing the LCD knob
  23. xLCD bezel: parts preparation
  24. Mounting the xLCD I.
  25. Mounting the xLCD II.
  26. Installing the xLCD assembly
  27. Securing the xLCD assembly
  28. Door seal: parts preparation
  29. Attaching the top seal
  30. Attaching the side seals
  31. Magnet holders: parts preparation
  32. Assembling the magnet holders
  33. Installing the magnet holders
  34. Hinges: parts preparation
  35. Installing the door-hinge-in parts
  36. Installing the door-hinge-out I.
  37. Installing the door-hinge-out II.
  38. Door panel: parts preparation
  39. Door panel: removing the protective film
  40. Installing the door panel
  41. Assembling the door handle
  42. Securing the door handle
  43. Haribo time
  44. Done
• 9. Calibration & First run
• Manual changelog