1. Tools necessary for this chapter

Prusa CORE One+ conversion kit

• 1A. Introduction
• 1B. MK4S Inspection
• 1C. Printer Disassembly
• 1D. Component Prep
• 2. Base assembly
• 3. Back assembly
• 4. Heatbed assembly
  1. Tools necessary for this chapter
  2. Heatbed: parts preparation
  3. Heatbed Cable Assembly 1
  4. Heatbed Cable Assembly 2
  5. Bed-cable-cover-bottom: parts preparation
  6. Attaching the cable cover
  7. Heatbed carriage: parts preparation
  8. Preparing the heatbed carriage
  9. Installing the expansion joints
  10. RGB LED strip: parts preparation
  11. Installing the LED strip
  12. Attaching the LED strip diffuser
  13. Covering the RGB LED strip
  14. Guiding the RGB LED strip cable
  15. Bearing Lubrication Preparation
  16. Bearing Lubrication
  17. Bed mounts: parts preparation
  18. Assembling the bed mounts
  19. Securing the bed mounts
  20. Bed mounts: inserting the nuts
  21. Assembling the CORE-One-bed-spacer-rear
  22. Installing the bed-mount-right
  23. Installing the bed-mount-left
  24. Mounting the heatbed: parts preparation
  25. Mounting the heatbed
  26. Tightening the heatbed
  27. Covering the cables: parts preparation
  28. Guiding the heatbed cables
  29. Covering the heatbed cables
  30. Mounting the heatbed: parts preparation
  31. Attaching the heatbed assembly
  32. Mounting the heatbed assembly: rear motor
  33. Mounting the heatbed assembly: front motor left
  34. Mounting the heatbed assembly: front motor right
  35. Attaching the heatbed cables I.
  36. Attaching the heatbed cables II.
  37. Securing the heatbed cables: parts preparation
  38. Securing the textile sleeve
  39. Guiding the heatbed assembly cables
  40. Connecting the heatbed power cables
  41. Haribo time
• 5. CoreXY assembly
• 6. Nextruder assembly
• 7. Bodywork & Electronics
• 8. Trim, Door & xLCD
• 9. Calibration & First run
• Manual changelog