English
1. Introduction
Step 1 of 7 (Chapter 1 of 5)
Contents
Comments
⬢Welcome to the guide for unboxing, calibrating, and setting up your Prusa CORE One. Follow these steps to ensure your printer is ready for its first print.
Although the Prusa CORE One comes pre-assembled, the LCD must be installed before printing, as it is removed for transport protection.
Do not install the LCD at this moment; wait for the appropriate instructions later in the guide.
Do not discard the packaging! Keep the original packaging and protective foam. The product, or any of its parts, must be packed in these for service or warranty shipping to prevent damage.
Contents
Prusa CORE One (assembled) (1.01)
- 1. Introduction
- 2. Unpacking the printer
- 3. Mounting the xLCD
- 4. Calibration & First run
- Manual changelog
There are some quirks in the instructions a couple of times, but the comment section helped a lot. Always check the comments. skip the complaints and focus on the very helpful advice you get from the great community.
First print done (no! not the Benchy) and it looks fine.
now for the fine tuning....