EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
  • 日本語
Login

Service menu - Factory Reset

Menu

Service menu - Factory Reset

Service menu - Factory Reset
Relevant for:
MMU2S
Last updated 5 years ago
Service menu - Factory Reset
 Difficulty
Moderate
 Steps
3
 Available languages
CSPLESDEITFRJA

Step 1 Introduction

Introduction
Introduction
Introduction
⬢This guide will take you through the factory reset of the MMU2 unit.
⬢Read the entire guide first to know, what is needed in order to get a successful factory reset.
This feature is available in firmware starting version 1.0.1, but it is recommended to upgrade to the 1.0.3 first. Keep in mind this is a separate firmware and is flashed directly to the MMU2 board, not to the Einsy board.
The firmware for the MMU2 unit is available for download on our site together with the firmware for the printer: prusa3d.com/drivers

Step 2 Entering the service menu

Entering the service menu
Entering the service menu
Entering the service menu
⬢How to enter the secret service menu:
⬢Start with the printer TURNED OFF.
⬢TURN the printer ON and let it boot all the way. Then, reset the printer using the "X button" next to screen and immediately press the middle button on the MMU2 unit and hold until all LEDs turn red.
⬢After the sequence is finished, following LEDs will light up:
⬢LED 1 - both LEDs are on
⬢LED 5 - only red LED is on

Step 3 Erasing the EEPROM

Erasing the EEPROM
Erasing the EEPROM
⬢Using the left/right button select LED 2 and confirm by pressing the middle button (this will unlock the EEPROM erase function). Visually nothing will happen.
⬢Using the left/right button select LED 3 and confirm by pressing the middle button (this will erase the EEPROM).
⬢Wait until the board erases its memory and restarts itself. All LEDs will flash once, then the first LED will turn green. The board is now erased and ready.
Note you've just deleted all stored values, you should perform Service menu - Individual Filament Calibration
Was this guide helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us